Daily use and maintenance of vehicles

Firstly, tire inspection

Every month, the tire pressure should be checked at room temperature, and if it is lower than the normal standard, the tire pressure should be replenished in a timely manner. The air pressure should not be too high or too low, otherwise it will affect driving safety. Check the cracking of the tires and replace them in a timely manner when there are safety hazards. When selecting tires, the model should be consistent.

Secondly, maintenance and inspection of the battery

Check if the battery is firmly fixed, and the electrolyte should be between the upper and lower limits. When approaching the offline line, timely add electrolyte or distilled water to the high-level line. Keep the positive and negative cables of the battery in good contact and keep the battery clean and dry. Vehicles that have been stored for a long time should remove the positive and negative cables of the battery, and reconnect the wires after about half a month. After starting the engine for about 20 minutes, if the battery level is significantly low, it should be charged in a timely manner.

Thirdly, check the liquid level of the clutch master cylinder

If the clutch fluid level is between high and low, it indicates normal operation. If it is below the standard line, it may be due to damage to the master cylinder or slave cylinder cup. When the engine is running, it will be difficult or impossible to shift gears. Please go to the nearest maintenance station for maintenance immediately.

Fourth, Inspection of Brake Fluid Level

If the braking is also between high and low, it indicates normal operation. If the brake fluid is close to or below the lower limit, it indicates that there may be leakage or excessive wear on the brake shoes in the system. It should be promptly repaired at a repair station. When adding brake fluid, it is necessary to pay attention to adding the same model of brake fluid to prevent damage to the leather cup, and to protect the paint to prevent corrosion of the paint surface.

Fifth, Engine coolant level inspection

When the engine is in a hot state, do not open the radiator cap, otherwise it may be scalded by splashed coolant or high-temperature steam. After the engine cools down, check that the coolant level should be between full and low. Otherwise, distilled water, purified water, or refrigerant should be added. The liquid level after adding water should not exceed full level. If it is found that the coolant decreases rapidly in a short period of time, the cooling system should be checked for leaks or inspected at a repair station.